Serving the Eau Claire area  ·  (534) 444-6239  ·  Open Mon-Sat 7am-6pm
📞 (534) 444-6239 Free Quote

Spray Foam Insulation in Seymour, WI (54720) · Local Professionals

Eau Claire Spray Foam Insulation · Fast response in Seymour and the Eau Claire area · Free estimate 24h

✅ Written Estimates with R-Value & Thickness Specs 🛡️ Fully Insured 💸 Free Quote 24h 🕐 Mon-Sat 7am-6pm
+28Verified Reviews
14Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Fully Insured✅ Written Estimates with R-Value & Thickness Specs

Seymour sits just outside Eau Claire, and homes here face the same winter cold and moisture challenges that define the whole valley: rim joists at the foundation line, attics that leak warm humid air into the roof cavity, and rooms over garages that never quite stay warm. We've been sealing and insulating Seymour properties since 2012, and we know exactly where the heat goes in these mid-century ranches and full-basement homes.

Most Seymour homeowners call us because a heating bill has climbed past what they can afford, a bedroom stays cold no matter how high the thermostat goes, or moisture shows up in the attic or crawl space come winter. We show up with a clear assessment, honest pricing, and spray foam that stops the air leaks and moisture migration that older construction leaves behind.

Spray Foam Insulation in Seymour (54720)

Seymour's housing stock runs mostly to mid-century ranches built over full basements, the same construction type that fills Eau Claire and the surrounding counties. That means rim joists and band joists at the top of the foundation wall, where cold air settling off the Chippewa River meets the warm rim beam every winter. It also means attics with top plates and roof penetrations that leak, where stack effect pushes warm humid indoor air up into the roof cavity. In this IECC zone 6A climate, that moisture meets cold roof sheathing and drives ice dams along the eaves. Crawl spaces, if present, face the same vapor drive from below, and rooms over garages or attached shops swing wildly in temperature because the floor above is open to an uninsulated or poorly insulated space below.

Our team has been installing spray foam in Seymour and across the Eau Claire area for over a decade. We seal rim joists, spray attics, inject walls, and replace contaminated or failed insulation. We work in occupied homes with a clear re-entry window, and we leave the property clean.

Our services in Seymour

How a Job Works in Seymour

We start with a free on-site assessment. We walk your attic, crawl space, or rim joist area, identify the air leaks and moisture risk, and give you a written estimate with R-value and thickness specifications so you know exactly what you're paying for and what code requires at your address.

On the work day, our fully insured crew sets up mechanical ventilation and seals off the space we're spraying. We apply closed-cell or open-cell foam at the thickness your estimate calls for, controlling the drum temperature and ratio so the foam cures properly. If insulation has to come out first, we remove it and haul it away. Most Seymour homes have tight attic or crawl space access, so we plan for that and work carefully around HVAC ducts, plumbing, and electrical runs.

Once the foam has cured, we do a final walkthrough with you, answer questions, and explain the re-entry window (typically twenty-four to forty-eight hours). Your property is clean and ready to use.

Attic spray foam in Seymour typically runs from $1.50 per square foot for open-cell foam to $1.20 per board foot for closed-cell, depending on the thickness and R-value your attic needs and what the building code requires at your address. Rim joist and band joist sealing starts around $650. Crawl space foam starts at $2,500. Wall injection (for closed walls with no cavity insulation, common in older Seymour homes) runs from $2 per square foot. Insulation removal runs from $950, and full replacement or re-insulation starts at $2,800. The biggest cost factors are the area to cover, the R-value and thickness specified, whether you choose open or closed cell, what has to be removed first, and how tight the access is. Call us at (534) 444-6239 for a free estimate tailored to your home and your budget.

✅ Written Estimates with R-Value & Thickness Specs, fully insured for work in Seymour and nearby areas.

I live in a mid-century ranch near downtown Seymour with a full basement. What's the most cost-effective place to start?
The rim joist and band joist at the top of the foundation wall. That's where cold air off the Chippewa River settles against the foundation every winter, and it's the single biggest driver of heating bills in Seymour homes like yours. Sealing that space with closed-cell foam stops the air leak and the moisture that comes with it. If your attic is also leaking (ice dams, damp insulation, or warm spots in winter), we tackle that next. Call (534) 444-6239 and we'll walk through the priorities with you.
I found damp insulation in my Seymour attic this winter. Do I just spray foam over it?
No. Wet or contaminated insulation has to come out before any foam goes in. Moisture trapped under new foam will keep degrading the wood and the insulation itself. We remove the old insulation, let the attic dry if needed, seal the air leaks that let the moisture in, and then spray the foam. It costs more upfront, but it's the only way to fix the problem instead of burying it. Call us at (534) 444-6239 to schedule an assessment.
How much does it cost to spray foam a Seymour attic?
A typical Seymour ranch attic runs $1.50 to $3 per square foot, depending on the area, the R-value specified, and whether old insulation has to come out first. A 1,200-square-foot attic might run $1,800 to $3,600 for open-cell foam, or more for closed-cell if you need higher R-value. The exact price depends on what we find on site. Call (534) 444-6239 for a free written estimate with R-value and thickness specs.
Who enforces the energy code and R-value requirements for spray foam in Seymour?
Seymour's building official and the Wisconsin energy code set the R-value and thickness your attic, rim joist, and walls need. The building code also governs the ignition barrier and thermal barrier that spray foam requires (the fifteen-minute thermal barrier is the requirement most installers misunderstand). We follow what the code requires at your address, and we help you understand what applies. Permits vary by city, so we confirm with the Seymour building department what's needed for your job.
Can we stay in the house while you spray foam the attic?
Yes. We set up mechanical ventilation during the work and seal the space we're spraying so fumes don't enter your living area. Most homeowners stay home. We ask you to keep the re-entry window in mind: typically twenty-four to forty-eight hours before the attic or crawl space is safe to use again. If you have questions about your specific setup, call (534) 444-6239.
Are you fully insured for spray foam work in Seymour?
Yes. We carry general liability and workers' compensation insurance. Any contractor you hire should be able to verify their insurance, and we can provide proof of ours. That's your protection if something goes wrong on your property.
When is the best time to spray foam a Seymour attic or rim joist?
Fall and early winter are our busiest season because that's when homeowners notice heating bills climbing and moisture showing up in attics and crawl spaces. If you can schedule in late summer or early fall, you'll beat the rush and have the work done before the cold snap hits. But if you spot a problem mid-winter, call us anyway. We work year-round, and getting the air leak sealed before spring is worth it.
Why choose us?

Trusted professionals since 2012

🏅

Insured contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Fully Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sat 7am-6pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Spray Foam Insulation Services in Eau Claire

All your work handled by qualified professionals in Eau Claire

Attic Spray Foam Insulation

Attic foam that stops Eau Claire's ice dams at the source

Included in your service

  • Roof deck sealed to curb ice dams along Eau Claire eaves
  • Attic plane air sealed at top plates in zone 6A conditions
  • Stops stack effect moisture reaching cold Chippewa Valley roofs
  • Works on Third Ward bungalow and Altoona subdivision attics alike
Learn more→

Closed Cell Spray Foam Insulation

Dense closed cell foam built for Eau Claire's cold basements

Included in your service

  • Closed cell foam applied along full basement rim joists
  • Seals cold air settling off the Chippewa River each winter
  • Adds structural rigidity for older Third Ward foundation walls
  • Blocks condensation risk common in zone 6A basement cavities
Learn more→

Open Cell Spray Foam Insulation

Open cell fill for Eau Claire's uneven old wall cavities

Included in your service

  • Fills stud cavities in Third Ward and downtown wall framing
  • Expands fully in mid-century ranch walls across Eau Claire
  • Cuts drafts tied to Chippewa Valley winter stack effect
  • Dampens sound in newer Altoona and Lake Hallie subdivisions
Learn more→

Wall & Injection Foam Insulation

Injection foam for finished walls across Eau Claire County

Included in your service

  • Small injection holes drilled in Third Ward lath and plaster
  • Fills gaps left in mid-century Eau Claire wall framing
  • No demolition needed on finished downtown bungalow walls
  • Adds coverage before another Chippewa Valley heating season
Learn more→

Crawl Space Spray Foam Insulation

Crawl space foam for Eau Claire's cold, damp foundations

Included in your service

  • Foam sealed along crawl space walls near full basement areas
  • Cuts cold floor drafts common in Eau Claire winters
  • Blocks moisture at band joists in Dunn county crawl spaces
  • Addresses condensation risk typical of zone 6A foundations
Learn more→

Rim Joist & Band Joist Spray Foam

Rim joist foam for every Eau Claire full basement

Included in your service

  • Rim and band joists foamed at the foundation top plate
  • Blocks cold air settling off the Chippewa River in winter
  • Fits full basements found under nearly every Eau Claire home
  • Cuts condensation risk common to zone 6A rim joist cavities
Learn more→

Garage Spray Foam Insulation

Garage foam that warms rooms over garages near Altoona

Included in your service

  • Garage ceiling foam under bonus rooms in Lake Hallie homes
  • Seals garage walls against Eau Claire winter cold
  • Evens out temperatures in rooms over Altoona subdivisions
  • Cuts drafts tied to zone 6A heating season demand
Learn more→

Metal Building & Barndominium Spray Foam

Metal building foam for Chippewa Valley pole barns

Included in your service

  • Foam applied to metal panels in Chippewa Valley pole barns
  • Controls condensation on barndominium roof purlins here
  • Keeps shops usable through long Eau Claire winters
  • Handles wide seasonal swings across the surrounding counties
Learn more→

Commercial & New Construction Spray Foam

Commercial and new build foam across the Chippewa Valley

Included in your service

  • Foam scheduled around framing stages on Eau Claire builds
  • Covers commercial sites across Chippewa and Dunn counties
  • Fits new subdivisions reaching toward Altoona and Lake Hallie
  • Free estimates for zone 6A new construction projects
Learn more→

Insulation Removal

Clearing out old insulation across Eau Claire homes

Included in your service

  • Old insulation cleared from Third Ward attic spaces
  • Removal from basements common under Eau Claire homes
  • Clears settled material from mid-century ranch walls
  • Prepares attics for new foam before winter heating season
Learn more→

Insulation Replacement & Re-Insulation

Fresh foam insulation for Eau Claire's older housing stock

Included in your service

  • New foam installed in Third Ward attic spaces
  • Re-insulated rim joists under full Eau Claire basements
  • Replaces uneven fill in mid-century Chippewa Valley walls
  • Closes gaps tied to zone 6A heating season losses
Learn more→

Air Sealing

Air sealing that targets Eau Claire's stack effect losses

Included in your service

  • Top plates sealed against Eau Claire stack effect drafts
  • Rim joist penetrations closed in full basement foundations
  • Reduces ice dam risk from Randall Park to Lake Hallie
  • Blower door tested results for zone 6A homes
Learn more→
Verified client reviews

28+ Verified Client Reviews in Eau Claire

⭐⭐⭐⭐⭐ 4.9/5 · 28 verified Google reviews

Free Quote

Get Your Free Quote

Spray Foam Insulation in Eau Claire · Response within 24h · No commitment · ☎ (534) 444-6239

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Fully Insured 📍 On-site visits included in Eau Claire ✅ No hidden fees 🕐 Available Mon-Sat 7am-6pm